![]() Note: Whenever this document references the ESP-880 it applies equally to the ESP-880A and ESP880AD, unless otherwise specified. ![]() The purpose of this document is to provide programmers and integrators the necessary details on the available commands, their behavior and syntax. This protocol provides a communication mechanism for Bose ControlSpace, PowerMatch and PowerShare products to interface with third-party control systems such as AMX, Crestron, Extron, or any other controller capable of following this protocol. ![]() L ControlSpace EX-1280C, EX-12AEC, and EX-440C conference processors l ControlSpace EX-1280 processor l ControlSpace ESP-880, ESP-1240, ESP-4120, ESP-1600 processors l ControlSpace ESP-00 Series II, ESP-00, ESP-88 processors l PowerMatch PM8500N, PM8250N, PM4500N, PM4250N amplifiers l ControlSpace WP, EP and EX DanteTM Endpoint audio interfaces l PowerShare PS404D, PS604D amplifiers This ControlSpace® Serial Control Protocol document covers the following products: Set/Get Module Parameter (SA, GA), Invoke Module Action (MA)Ħ.1.7 Surround Input Module Ħ.1.14 Acoustic Echo Canceller Module Ħ.1.18 AMM Gain Sharing Module Ħ.1.19 AMM - Gated Module (Legacy) Ħ.1.20 AMM - Gated Module (Enhanced) Ħ.1.22 Conference Room Router Module Ħ.1.43 Dynamic EQ Module Ħ.1.45 Predictive Feedback Suppression Module Ħ.2 PowerMatch® and PowerShare Module IndicesĦ.2.2 Signal Generator Module ħ.2 Input Gain (IG) ħ.4 Phantom Power (PP) ħ.6 Read Signal Level (RSL) ħ.7 Read/Write Logic Output (RLO/WLO) ħ.8 Read Logic Input (RLI) ħ.9 Set Logic Event (EVNT) ħ.10 Set Event Notification IP Address (SASIP) Ĩ.1 Device Subscription Support (SUB without Argument)Ĩ.2 Subscribing for Data Change (SUB with Argument) Using Serial-over-Ethernet (WP, EP and EX Endpoints)Ĥ.3 Set Group Level Increment/Decrement (SH)Ĥ.5 Set/Get Room Combine (SRC, GRC) ĥ.8 Set/Get Standby Status (SY, GY) ĥ.9 Get Configuration (GC) ĥ.10 Set/Get Fault Status (SF, GF) ĥ.11 Clear Fault/Alarms (CF) ĥ.12 Set/Get Alarm Reporting/Status (SR, GR) ĥ.13 Get/Clear Alarm History/Log (GH, CH) ![]() Using Serial-over-Ethernet (ESP, EX, PowerMatch and PowerShare ) Using the RS-232 Serial Port (ESP and EX only) File Info : application/pdf, 89 Pages, 980.62KB Document Document ControlSpace SerialControlProtocol 5.9 ControlSpace® ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |